When you overload your PTO Clutch...

Kinja'd!!! "JawzX2, Boost Addict. 1.6t, 2.7tt, 4.2t" (jawzx2)
06/02/2017 at 21:33 • Filed to: tractorlopnic

Kinja'd!!!0 Kinja'd!!! 1
Kinja'd!!!

Stock Photo

So, we got a new Tar River BDR-165 Drum Mower... It recommends 30HP minimum, and after assembling it I tried it out with the 29HP Ford, the tractor has JUST enough power to spin it, but apparently my PTO clutch was slipping a little bit, maybe missadjusted, maybe worn, maybe just over loaded.... any way, first there’s the telltale smell of hot friction material... and I ignore it... one pass of the field will be fine...right?

*BANG* clunk-chunk....

uh oh...

It still works, I think I probably just detonated a single puck of the friction plate, but at the very least its un-balanced now :/

Kinja'd!!!

something like this, but hopefully not quite that bad....

Kinja'd!!!

or maybe it threw a spring...?

The friction plate’s not very expensive, but you have to split the tractor in two to replace it. and since we have a cab, we have to remove the cab too.

poop.

I think I’ll run it for the summer as long as I can, and maybe work on it over the winter.... provided I have a garage available by then.

:P

What are the chances my transmission input shaft bearing blows?


DISCUSSION (1)


Kinja'd!!! The Crazy Kanuck; RIP Oppositelock > JawzX2, Boost Addict. 1.6t, 2.7tt, 4.2t
06/02/2017 at 23:26

Kinja'd!!!0

I dream of 29hp PTO. Mine is 18.7 hp at the PTO.